 |
 |
 |
|
|
|
[Sponsors] | ||||
December 6, 2009, 06:55
|
Need advice turbogrid
|
#1 |
|
New Member
Join Date: Dec 2009
Posts: 1
Rep Power: 0  |
Am still a bit new to CFX, trying to run simulation for contra-rotating rotors...
Have looked for relevant tutorial but unable to find any reference regarding multi-stage analysis.... Can anyone give me some guidence here? Much appreciated  ..... ......
|
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GE rotor B geometry for Ansys turbogrid | sonny | ANSYS Meshing & Geometry | 3 | May 15, 2013 22:36 |
| Can I use Turbogrid to mesh a wind turbine blade? | Henry Liu | CFX | 10 | November 10, 2011 05:41 |
| Axial blade simulation, TurboGrid a must? | Gentry | CFX | 1 | March 19, 2009 11:20 |
| Meshing or Topology generation error in TurboGrid? | jetcheve | CFX | 2 | September 30, 2008 09:35 |
| How to refine leading edge mesh in TurboGrid 10 | Christian | CFX | 7 | May 30, 2006 14:24 |
Linear Mode
