Transient outlet boundary condition problem

jwillie2000 · December 7, 2009, 06:11

Hello Eveyone,

I am doing premixed combustion in a compressible transient flow simulation using CFX. I first had a converged steady state simulation before switching to unsteady. My trouble is, after some time, i am getting this message in the output file:

"
****** Notice ****** |
| A wall has been placed at portion(s) of an OUTLET |
| boundary condition (at 100.0% of the faces, 100.0% of the area) |
| to prevent fluid from flowing into the domain. |
| The boundary condition name is: out. |
| The fluid name is: Propane Air Mixture. |
| If this situation persists, consider switching |
| to an Opening type boundary condition instead.
"

The outlet boundary i used is "pressure outlet" and the and i have "velocity inlet" for the air and "mass flow inlet" for the fuel. Because the outlet is reflecting i think pressure waves could be moving in into the flow, which is what I would expect. But do I have to specify any other boundary in addition to just a "pressure outlet"?

Thanks!

Jimmy

ghorrocks · December 7, 2009, 17:07

Whether this is a problem depends on your model. Do you need to have correct reverse flow? If so you need an opening. If it does not matter then stick with an outlet. Even better, move the boundary condition further away so it always has flow in one direction.

December 7, 2009, 06:11	Transient outlet boundary condition problem	#1
jwillie2000 Member James Willie Join Date: Mar 2009 Posts: 81 Rep Power: 17	Hello Eveyone, I am doing premixed combustion in a compressible transient flow simulation using CFX. I first had a converged steady state simulation before switching to unsteady. My trouble is, after some time, i am getting this message in the output file: " **** Notice **** \| \| A wall has been placed at portion(s) of an OUTLET \| \| boundary condition (at 100.0% of the faces, 100.0% of the area) \| \| to prevent fluid from flowing into the domain. \| \| The boundary condition name is: out. \| \| The fluid name is: Propane Air Mixture. \| \| If this situation persists, consider switching \| \| to an Opening type boundary condition instead. " The outlet boundary i used is "pressure outlet" and the and i have "velocity inlet" for the air and "mass flow inlet" for the fuel. Because the outlet is reflecting i think pressure waves could be moving in into the flow, which is what I would expect. But do I have to specify any other boundary in addition to just a "pressure outlet"? Thanks! Jimmy

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
outlet boundary condition for compressor modeling	siamak1424	FLUENT	3	August 8, 2009 05:55
Transient Inlet boundary condition - fully develop	Omer	CFX	3	November 28, 2006 16:22
Periodic flow boundary condition problem	sudha	FLUENT	3	April 28, 2004 08:40
UDF for transient boundary condition?	Shankar	FLUENT	1	November 22, 2003 08:10
a problem with Boundary condition	M Rad	Main CFD Forum	12	November 27, 1998 12:49

December 7, 2009, 17:07		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	Whether this is a problem depends on your model. Do you need to have correct reverse flow? If so you need an opening. If it does not matter then stick with an outlet. Even better, move the boundary condition further away so it always has flow in one direction.