|April 1, 2010, 06:09||
how to study a simple rotating blade?
Join Date: Jan 2010
Posts: 3Rep Power: 8
I'll tell you now what my problem is. I have to simulate the behavior of a simple rectangular shaped blade of a vertical axis hydraulic turbine. Only a blade to make the comparison with a mathematical model that I have made. I am working in this way. In ICEM I create two domainsne cylindrical (with the) which describes the movement of the rotary blade and the other describing instead the steady inflow and outflow of water. What I need is get the torque that makes the water on the blade. I do not know if I'm proceeding on the right way. I work with a Transient Rotor-stator interface. In your opinion, okay?
Looking at the streamlines does not seem to be very correct. What should I do?
let me know thanks
|April 1, 2010, 06:23||
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 12,832Rep Power: 100
What you are doing sounds correct.
What does not look correct about the streamlines? I can guess the reason anyway - draw streamlines using the variable "Velocity in stationary frame".
|Thread||Thread Starter||Forum||Replies||Last Post|
|ROTATING TURBINE BLADE SIMULATION||Anant||FLUENT||2||March 31, 2011 10:57|
|stress analysis of a rotating beam(wind blade)||Cheyannne||ANSYS||0||October 19, 2009 17:06|
|Setting up a point monitor rotating with the blade||Hamidur||CFX||1||September 13, 2008 17:00|
|2D Compressor cascade study using DFLVR blade||kiran||FLUENT||1||May 24, 2007 15:01|
|Flow study through Turbine Blade passage||Subrata||FLUENT||1||May 4, 2007 11:28|