creating subdomains in DM

Airone · May 11, 2010, 20:16

Hi everyone,
I am a beginner in Designmodeler. I did lots of tutorials and read the help but can't figure out this simple question. How do we do to create more than 1 body?

I would like to create 2 subdomains to help me in my meshing. Do I need to create more than 1 body (or more than 1 part I don't know) to be able to do that ?

In fact, I extruded a profile in one direction and created another extrusion in the opposite direction but it doesn't create another body but merges the 2 automatically. Same thing when I use another profile and I want it to be connected to the other one.
I know it is possible because there is a tutorial (Workbench and Polyflow) where they show the geometry having 2 subdomains and 2 parts but it basically just 2 cubes stuck one on the other.

Thank you for your help

Lance · May 12, 2010, 02:07

Use the freeze command to create more than one body. In your example, after you have done the first extrusion, use freeze and then create the other extrusion.

Airone · May 12, 2010, 16:03

Thank you for your answer. I noticed that frozen a part creates a new body but was not sure it was the solution.

May 11, 2010, 20:16	creating subdomains in DM	#1
Airone New Member Join Date: May 2010 Posts: 6 Rep Power: 15	Hi everyone, I am a beginner in Designmodeler. I did lots of tutorials and read the help but can't figure out this simple question. How do we do to create more than 1 body? I would like to create 2 subdomains to help me in my meshing. Do I need to create more than 1 body (or more than 1 part I don't know) to be able to do that ? In fact, I extruded a profile in one direction and created another extrusion in the opposite direction but it doesn't create another body but merges the 2 automatically. Same thing when I use another profile and I want it to be connected to the other one. I know it is possible because there is a tutorial (Workbench and Polyflow) where they show the geometry having 2 subdomains and 2 parts but it basically just 2 cubes stuck one on the other. Thank you for your help

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Commercial meshers] Fluent msh and cyclic boundary	cfdengineering	OpenFOAM Meshing & Mesh Conversion	48	January 25, 2013 03:28
[blockMesh] Cyclic BC's: Possible face ordering problem? (Channel flow)	sega	OpenFOAM Meshing & Mesh Conversion	3	September 28, 2010 12:46
[mesh manipulation] Using createPatch in place of couplePatches	sripplinger	OpenFOAM Meshing & Mesh Conversion	8	November 13, 2009 07:14
Problems with Meshing: Collapsed Cells	Emmanuel Resch	Siemens	1	July 30, 2007 03:02
Gerris software installation	mer	Main CFD Forum	2	November 12, 2005 08:50

May 12, 2010, 02:07		#2
Lance Senior Member Lance Join Date: Mar 2009 Posts: 669 Rep Power: 22	Use the freeze command to create more than one body. In your example, after you have done the first extrusion, use freeze and then create the other extrusion.

May 12, 2010, 16:03		#3
Airone New Member Join Date: May 2010 Posts: 6 Rep Power: 15	Thank you for your answer. I noticed that frozen a part creates a new body but was not sure it was the solution.