Map Temperature Field for Structural Analysis

hydro · May 11, 2010, 15:00

Hi again,

is there a way to map the temperature field from a cht analysis to a structural analysis in ansys (classic or workbench..)?

Regards!

stumpy · May 11, 2010, 17:22

I beleive there's a beta feature in CFD-Post that will do this. Not sure of the details though, I would ask Ansys support if nobody here knows.

Pocket · May 11, 2010, 21:59

just pump it through a thermal analysis

i know, its not very nice to do the same temperature solution twice, but if you apply most or even all of the surface temperatures, it will be fairly quick.

Plus, i remember reading in the Ansys help, that load passing from CFX to Structural only supports pressure loads.

May 11, 2010, 15:00	Map Temperature Field for Structural Analysis	#1
hydro New Member Join Date: Apr 2010 Posts: 9 Rep Power: 16	Hi again, is there a way to map the temperature field from a cht analysis to a structural analysis in ansys (classic or workbench..)? Regards!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
transient temperature field with constant velocity	Törnquist	CFX	0	September 16, 2003 04:22
overwrite temperature field using usrsrc	jess	CFX	0	November 13, 2002 02:50
Pipe wall temperature	Fred Uckfield	Main CFD Forum	25	May 22, 2000 14:37
I wish to find the proper model to validate the temperature field.	G.H.Lee	Main CFD Forum	1	May 6, 1999 02:05
Question concering about validating Temperature field	ghlee	Main CFD Forum	1	December 1, 1998 12:36

May 11, 2010, 17:22		#2
stumpy Senior Member Join Date: Apr 2009 Posts: 531 Rep Power: 21	I beleive there's a beta feature in CFD-Post that will do this. Not sure of the details though, I would ask Ansys support if nobody here knows.

May 11, 2010, 21:59		#3
Pocket New Member Daniel Paukner Join Date: Apr 2010 Posts: 17 Rep Power: 16	just pump it through a thermal analysis i know, its not very nice to do the same temperature solution twice, but if you apply most or even all of the surface temperatures, it will be fairly quick. Plus, i remember reading in the Ansys help, that load passing from CFX to Structural only supports pressure loads.