Problem converging with a set particle distribution

alastormoody11 · July 15, 2010, 04:44

Hi,

I am running a transient evaporating spray simulation in CFX 11 on a 8 mil mesh using a 8gb ram intel quadcore processor and I have successfully simulated the particle injection using the cone with primary breakup model however when i try to change the method of injection I am having tremendous trouble converging even for one time step. The problem is that when using the cone with primary breakup model all the particles injected were of size 500 micrometers however when using the rosin rammler the representative diameter is 60.7 micrometers so a lot of very small particles are ejected. Is there any way in which I can accelerate the convergence without prohibitively increasing the computational cost?

alastormoody11 · July 15, 2010, 04:46

I also tried using a normal distribution with the mean equal to Sauter mean diameter which 43.7 microns and encountered a similar problem I guess due to a similar reason

July 15, 2010, 04:44	Problem converging with a set particle distribution	#1
alastormoody11 Senior Member Join Date: Jun 2009 Posts: 100 Rep Power: 16	Hi, I am running a transient evaporating spray simulation in CFX 11 on a 8 mil mesh using a 8gb ram intel quadcore processor and I have successfully simulated the particle injection using the cone with primary breakup model however when i try to change the method of injection I am having tremendous trouble converging even for one time step. The problem is that when using the cone with primary breakup model all the particles injected were of size 500 micrometers however when using the rosin rammler the representative diameter is 60.7 micrometers so a lot of very small particles are ejected. Is there any way in which I can accelerate the convergence without prohibitively increasing the computational cost?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with a simple UDF to calculate cell-averaged particle values	kmayank	FLUENT	1	January 18, 2011 01:40
OF 1.6 \| Ubuntu 9.10 (64bit) \| GLIBCXX_3.4.11 not found	piprus	OpenFOAM Installation	22	February 25, 2010 13:43
cfx particle convergence problem	bharath	CFX	0	November 11, 2009 08:34
DPM particle size distribution in Fluent	Pete	FLUENT	5	July 7, 2008 12:22
Problem in Reporting Unsteady Particle Fates	Nelson	FLUENT	0	August 23, 2006 20:24

July 15, 2010, 04:46		#2
alastormoody11 Senior Member Join Date: Jun 2009 Posts: 100 Rep Power: 16	I also tried using a normal distribution with the mean equal to Sauter mean diameter which 43.7 microns and encountered a similar problem I guess due to a similar reason