Simulate flow into a enclosed volume

solimcfd · July 21, 2010, 12:56

I just recently started using CFX, so I am no expert. I was wondering if anyone could help me. I have a cylindrically shaped volume with one inlet. At the beginning the volume contains only air and then slowly a fluid is poured inside. I would like to simulate the fluid entering the inlet and filling the volume and at the same time how the air leaves or is displaced.
My first problem is that this fluid inlet is at the same time an outlet for the air. I am not quite sure how to define the boundary conditions for this surface.
Another issue I have is the interaction between the air and fluid. Do I need to use a multi-phase model, and how should I best do this?
I would appreciate any help! Thanks

ghorrocks · July 22, 2010, 06:15

Try the free surface flow over a bump tutorial example which is installed with CFX. Assuming what you are talking about is where you have distinct air and liquid phases this is a good introduction.

July 21, 2010, 12:56	Simulate flow into a enclosed volume	#1
solimcfd New Member Join Date: Jul 2010 Posts: 20 Rep Power: 15	I just recently started using CFX, so I am no expert. I was wondering if anyone could help me. I have a cylindrically shaped volume with one inlet. At the beginning the volume contains only air and then slowly a fluid is poured inside. I would like to simulate the fluid entering the inlet and filling the volume and at the same time how the air leaves or is displaced. My first problem is that this fluid inlet is at the same time an outlet for the air. I am not quite sure how to define the boundary conditions for this surface. Another issue I have is the interaction between the air and fluid. Do I need to use a multi-phase model, and how should I best do this? I would appreciate any help! Thanks

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
how to simulate jet flow?	Benny	FLUENT	18	May 12, 2014 10:53
Easy question: how to simulate water flow?	Freeman	FLUENT	6	March 4, 2009 02:31
volume fraction in multiphasic flow in fluent	max	FLUENT	0	February 16, 2009 08:08
volume fraction,mass fraction,bulk mass flow	nick	CFX	0	April 25, 2008 09:51
Terrible Mistake In Fluid Dynamics History	Abhi	Main CFD Forum	12	July 8, 2002 09:11

July 22, 2010, 06:15		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	Try the free surface flow over a bump tutorial example which is installed with CFX. Assuming what you are talking about is where you have distinct air and liquid phases this is a good introduction.