|
[Sponsors] |
August 22, 2010, 17:35 |
mesh interpolation
|
#1 |
Member
Join Date: Aug 2010
Posts: 31
Rep Power: 15 |
Dear All,
I am planning an FSI simulation on a compressor blade. In order to minimise numerical error I was thinking of using the same mesh for the structural and fluid analyses such that the need for interpolation between meshes is circumvented. Does anyone know if it is possible in Ansys to use the same mesh? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3D Hybrid Mesh Errors | DarrenC | ANSYS Meshing & Geometry | 11 | August 5, 2013 07:42 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 05:24 |
Surface interpolation schemes and parallelization | jutta | OpenFOAM Running, Solving & CFD | 0 | February 25, 2010 15:32 |
ICEM 10 mesh question | DAK565656 | CFX | 6 | May 8, 2007 13:16 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 19:10 |