 |
 |
 |
|
|
|
[Sponsors] | ||||
August 30, 2010, 07:39
|
surface ratio
|
#1 |
|
Member
Join Date: Jul 2010
Posts: 88
Rep Power: 4  |
Hello everyone.
Does anybody know if there are some constraints how high could be inlet surface/outlet surface ratio in CFX?? May it cause problems with solution??? Thank you for any opinions. |
|
|
|
|
|
August 30, 2010, 18:54
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 7,008
Rep Power: 60 |
No constraints that I am aware of. As the ratio gets large you will run into round off problems eventually, but go to double precision numbers and that will extend the ratio even further.
|
|
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 38 | March 6, 2013 16:47 |
| boundaries with gmshToFoam | ouafa | Open Source Meshers: Gmsh, Netgen, CGNS, ... | 7 | May 21, 2010 12:43 |
| Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | Open Source Meshers: Gmsh, Netgen, CGNS, ... | 0 | June 29, 2009 00:48 |
| Problem with Gmsh | nishant_hull | Open Source Meshers: Gmsh, Netgen, CGNS, ... | 17 | December 7, 2007 01:33 |
| CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |
Linear Mode
