|
[Sponsors] |
July 20, 2016, 01:59 |
How to get results on specific area
|
#1 |
New Member
tato
Join Date: Jul 2009
Posts: 13
Rep Power: 16 |
Dear colleagues,
How to get pressure information/results on specific area? Please refer to attached picture. I need to know pressure on each hole no.1, 2, and 3. Thank you in advance for your help. Regards, C.Moca |
|
July 20, 2016, 02:07 |
|
#2 |
Senior Member
Maxim
Join Date: Aug 2015
Location: Germany
Posts: 415
Rep Power: 12 |
in Post create a plane for each of the holes and evaluate your pressure etc on/through those planes.
|
|
July 20, 2016, 06:38 |
|
#3 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,700
Rep Power: 143 |
Or if a point measure of pressure is OK then put a monitor point on it (if you are in the solver) or a point on it (if you are in CFD-Post). This is simpler than planes, but only gives you pressure at a point.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Non overlap area fractions | saisanthoshm88 | CFX | 11 | September 17, 2015 18:42 |
tet results vs hex results | sivakumar | OpenFOAM Running, Solving & CFD | 0 | March 4, 2014 10:15 |
results in a specific point | rcerdeira | FLUENT | 1 | February 21, 2011 14:27 |
area weighted mass fraction-different results for different grid types | Lilly | Main CFD Forum | 0 | February 13, 2011 11:43 |
How to output results for specific elements - HELP | Dan | FLUENT | 0 | January 16, 2009 08:38 |