Mesh inverse volume - wind tunnel

roald · January 11, 2011, 12:36

Hi,

Hopefully someone can help. I am building a wind tunnel to test UAV engines as part of a project. I have created a version of it in soliworks and imported it into ansys workbench using the IGS format.

I am using CFX to simulate my models.

I need to mesh the volume of 'air' conatined within the wind tunnel. It is an open wind tunnel but I have placed caps on either end so i literally want to mesh the volume contained within. There are some complex shapes and turning veins inside etc which i obviously want to preserve also.

If anyone knows how to do this, it would be really really appreciated!

Many thanks!

ghorrocks · January 11, 2011, 16:45

Parasolid is a better format than igs, especially for complex surfaces.

Your description is a pretty typical simulation. Do the tutorials and things should be clearer. There are lots of pre-processing tutorials on the ANSYS Community website.

January 11, 2011, 12:36	Mesh inverse volume - wind tunnel	#1
roald New Member Join Date: Jan 2011 Posts: 1 Rep Power: 0	Hi, Hopefully someone can help. I am building a wind tunnel to test UAV engines as part of a project. I have created a version of it in soliworks and imported it into ansys workbench using the IGS format. I am using CFX to simulate my models. I need to mesh the volume of 'air' conatined within the wind tunnel. It is an open wind tunnel but I have placed caps on either end so i literally want to mesh the volume contained within. There are some complex shapes and turning veins inside etc which i obviously want to preserve also. If anyone knows how to do this, it would be really really appreciated! Many thanks!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Negative volume error in hybrid mesh	siw	ANSYS Meshing & Geometry	4	September 3, 2014 05:25
convergence problem when use pisoFoam, LES for wind tunnel case	Forrest_Lei	OpenFOAM	3	July 19, 2011 06:00
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 14:11
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55
defining velocity profile in a wind tunnel model	Erdem	FLUENT	0	June 20, 2006 13:00

January 11, 2011, 16:45		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,700 Rep Power: 143	Parasolid is a better format than igs, especially for complex surfaces. Your description is a pretty typical simulation. Do the tutorials and things should be clearer. There are lots of pre-processing tutorials on the ANSYS Community website.