|December 23, 2010, 18:29||
fluid pair models
Join Date: Sep 2010
Posts: 33Rep Power: 6
i am modeling a domain with 3phases ( i.e. air+water+sediment).
for defining model, i selected continues fluid for air and water and dispersed fluid for sediment in basic setting. in this state cfx want viscosity for sediment. what should i select it?
in fluid pair models tab, should i select free surface for air/water and particle model for water/sediment in interface transfer option ?
in experimental model, sediment don't move but in modeling with cfx sediment go out from end of channel. what is cause of it while velocity is same in both model?
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wind turbine simulation||Saturn||CFX||34||October 16, 2014 05:27|
|mass flow in is not equal to mass flow out||saii||CFX||2||September 18, 2009 08:07|
|What is the total energy for incompressible fluid?||Harry Dong||Main CFD Forum||12||February 4, 2006 01:55|
|My Revised "Time Vs Energy" Article For Review||Abhi||Main CFD Forum||2||July 9, 2002 09:08|
|Terrible Mistake In Fluid Dynamics History||Abhi||Main CFD Forum||12||July 8, 2002 09:11|