|January 19, 2011, 19:49||
inhomogeneous tank sloshing overflow error
Join Date: Jun 2010
Posts: 43Rep Power: 6
I am trying to model a sloshing liquid tank.
I have modeled a rectangular tank with a unit thickness. the side and bottom faces are wall with specified mesh displacement (Asinwt). and the top is opening BC.
It runs well with homogeneous but when I uncheck homogeneous to have inhomogeneous, after a couple of iterations i get overflow error.
How can I solve this?
In cfx-pre I also have this message :"In Analysis 'Flow Analysis 1': Export results are unavailable as no suitable boundaries exist for use as export surfaces. Mesh motion on a boundary invalidates its use as an export surface." what does it mean? is it important?
|August 2, 2012, 08:42||
Join Date: May 2012
Posts: 1Rep Power: 0
Hi dear hamed
I'm a hydraulic structure student of Tarbia Modares of Tehran.
I had a similar problem. But there's not any problem. It's not an error, it's just a warning.
I have some problem at the next steps of the problem. If you want I'll be happy to your synergy.
My email is: firstname.lastname@example.org
|Thread||Thread Starter||Forum||Replies||Last Post|
|nonNewtonian viscosity model||mhassani||OpenFOAM Programming & Development||5||January 7, 2013 10:27|
|Accessing phi from a fvPatchField at same patch||johndeas||OpenFOAM||1||September 13, 2010 20:23|
|OpenFOAM on MinGW crosscompiler hosted on Linux||allenzhao||OpenFOAM Installation||127||January 30, 2009 20:08|
|DecomposePar links against liblamso0 with OpenMPI||jens_klostermann||OpenFOAM Bugs||11||June 28, 2007 17:51|
|Problems of Duns Codes!||Martin J||Main CFD Forum||8||August 14, 2003 23:19|