CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   Need Help to Enable Wall Boiling Model in CFX (http://www.cfd-online.com/Forums/cfx/85423-need-help-enable-wall-boiling-model-cfx.html)

cjhaw February 25, 2011 02:15

Need Help to Enable Wall Boiling Model in CFX
 
Hi all,

I would like have the RPI Wall Boiling Model in CFX either CFX 11 or CFX 12. I realized that the model should exist in domain>Fluid Pair tab under mass transfer>Phase Change Model (just below Heat Transfer Coefficient Under Relaxation Factor). But it does not exist in my computer.

So here I would like to ask how can I have the model and hope that I can get your advice.

Thank you.

CJH

joey2007 February 25, 2011 14:17

Guess in 11 it was not there. If I correctly remind, it is there 12.1. Possibly you have to activate beta features.

cjhaw February 26, 2011 12:47

Quote:

Originally Posted by joey2007 (Post 297035)
Guess in 11 it was not there. If I correctly remind, it is there 12.1. Possibly you have to activate beta features.

Hi Joey,

Thank you for your reply. I had enabled the beta feature in edit>option. But the model still did not appear.

yasin.ramzani September 26, 2013 09:40

re: Need Help to Enable Wall Boiling Model in CFX
 
before searching for this model,
you should define at least two fluid in basic setting/fluid and particle definitions.
just below this in morphology section choose Droplets(phase change) for one of the fluid
hope this help you


All times are GMT -4. The time now is 09:40.