CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   CFX (http://www.cfd-online.com/Forums/cfx/)
-   -   How to put residuals as a variable (http://www.cfd-online.com/Forums/cfx/86490-how-put-residuals-variable.html)

mohammad March 24, 2011 00:11

How to put residuals as a variable
 
Hi every body
In the FAQ section of Ansys cfx about the convergence problem , I found this tip:" Do a test run with the residuals in the result file ...."

Could you please tell me how to put residuals as a variable for later investigation?

Regards

stumpy March 24, 2011 08:43

It's in CFX-Pre under "Output Control > Results".

mohammad March 27, 2011 04:02

Quote:

Originally Posted by stumpy (Post 300874)
It's in CFX-Pre under "Output Control > Results".

Hi stumpy,
I ticked the "Output Equation Residual " and I chose "ALL".
then, under Monitor Option > Monitor option > Monitor residual >" Full ".

After the run, In CFX-Post, I created a "Contour" and as a " Variable" to be assigned to that Contour , I just found .

is "P-Mass Residual" that variable that FAQ meant? or else what's wrong in the process above.

TNX a lot


All times are GMT -4. The time now is 16:24.