Help in meshing
1 Attachment(s)
Hello to everybody.
I have designed a racecar dualplane front wing and i am trying to run it in CFD. I have attached the model inside its boundary in .stp format. Problem is that i cannot apply any inflation in the model. Could anyone help me and make a correct mesh for this model? Thanks a lot! |
Anyone could help?
|
You might have more luck in the meshing forum.
But I doubt it. Meshing is tricky on complex geometries and I doubt many people have hours to spare to help you. You need commercial CFX support, not an internet forum. |
All times are GMT -4. The time now is 10:51. |