Help in meshing

Echidna · April 13, 2011, 05:25

Hello to everybody.
I have designed a racecar dualplane front wing and i am trying to run it in CFD. I have attached the model inside its boundary in .stp format.
Problem is that i cannot apply any inflation in the model. Could anyone help me and make a correct mesh for this model? Thanks a lot!

Echidna · April 15, 2011, 02:27

Anyone could help?

ghorrocks · April 15, 2011, 06:38

You might have more luck in the meshing forum.

But I doubt it. Meshing is tricky on complex geometries and I doubt many people have hours to spare to help you. You need commercial CFX support, not an internet forum.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing	David-CFD	ANSYS Meshing & Geometry	1	April 1, 2011 05:22
Best Meshing scheme for Cylinder	Nutrex	Main CFD Forum	4	July 29, 2008 11:03
Meshing locks workbench window.	andy2o	CFX	0	February 1, 2008 05:01
Singularity of grid?Volume meshing vs face meshing	Ken	Main CFD Forum	0	September 4, 2003 11:09
Volume Meshing & Face Meshing? singularity of grid	ken	FLUENT	0	September 4, 2003 11:08

April 15, 2011, 02:27		#2
Echidna Member Join Date: Jun 2010 Posts: 77 Rep Power: 15	Anyone could help?

April 15, 2011, 06:38		#3
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,700 Rep Power: 143	You might have more luck in the meshing forum. But I doubt it. Meshing is tricky on complex geometries and I doubt many people have hours to spare to help you. You need commercial CFX support, not an internet forum.