Results are time step dependent

ojha.mayank485 · May 9, 2011, 22:39

Hello all,

I am trying to simulate a moving mesh problem where the motion is governed by fluid flow. i.e force_y()@Region:CYLINDER

I created the mesh in ICEM and did a grid and time convergence study for a stationary cylinder at Re=100. The residuals have an rms of 1e-05. The results obtained were accurate for a stationary cylinder but when I used the same grid for mesh motion, the results (displacements) were time step dependent. getting close to correct results for tstep=0.01 but very low values for tstep=0.001

1.) In my case should the grid convergence be done for moving mesh or stationary mesh ???

Thank you very much.

Mayank

ghorrocks · May 10, 2011, 19:00

It may well be that your moving mesh model requires a different time step size. Looks like you need to repeat the convergence study with the moving mesh model.

May 9, 2011, 22:39	Results are time step dependent	#1
ojha.mayank485 New Member Mayank Ojha Join Date: May 2011 Posts: 22 Rep Power: 14	Hello all, I am trying to simulate a moving mesh problem where the motion is governed by fluid flow. i.e force_y()@Region:CYLINDER I created the mesh in ICEM and did a grid and time convergence study for a stationary cylinder at Re=100. The residuals have an rms of 1e-05. The results obtained were accurate for a stationary cylinder but when I used the same grid for mesh motion, the results (displacements) were time step dependent. getting close to correct results for tstep=0.01 but very low values for tstep=0.001 1.) In my case should the grid convergence be done for moving mesh or stationary mesh ??? Thank you very much. Mayank

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Transient simulation not converging	skabilan	OpenFOAM Running, Solving & CFD	14	December 16, 2019 23:12
HELP! time step too small?	meangreen	Main CFD Forum	6	May 31, 2018 10:41
How to write k and epsilon before the abnormal end	xiuying	OpenFOAM Running, Solving & CFD	8	August 27, 2013 15:33
directMapped problem	panda60	OpenFOAM Bugs	4	July 8, 2010 10:23
unsteady calcs in FLUENT	Sanjay Padhiar	Main CFD Forum	1	March 31, 1999 12:32

May 10, 2011, 19:00		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,703 Rep Power: 143	It may well be that your moving mesh model requires a different time step size. Looks like you need to repeat the convergence study with the moving mesh model.