 |
 |
 |
|
|
|
[Sponsors] | ||||
May 26, 2011, 07:24
|
Negative reference state enthalpy
|
#1 |
|
Member
Pratik Mehta
Join Date: Mar 2009
Posts: 32
Rep Power: 6  |
Hello Friends,
I am looking to do simulation of Fuel injection in IC engine. Thereby I needed to understand the similar case setup. I looked at the Spray dryer tutorial in CFX. I am not able to figure out that why there exist a negative reference state enthalpy settings. What is the logic behind it . PS:I would be glad to know how mathematically this number obtained. thank in advance for your response Best Greetings |
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Constant velocity of the material | Sas | CFX | 15 | July 13, 2010 08:56 |
| mass flow in is not equal to mass flow out | saii | CFX | 2 | September 18, 2009 08:07 |
| OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
| Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Native Meshers: blockMesh | 10 | April 2, 2007 14:00 |
| G95 + CGNS | Bruno | Main CFD Forum | 1 | January 30, 2007 00:34 |
Linear Mode
