how to use non-uniform source

iBra · July 2, 2011, 07:59

hi guys

i have a project contain a non-uniform source
PROBLEM DESCRIPTION
there is a receiver which absorbs heat flux (W/m^2). the heat flux in the surface of the receiver is non-uniform. I have the heat flux data as X,Y,Heat_Flux.
is it possible to insert this data to ansys cfx?
i try [Hot_Point] but the problem with this function. i cant enter the value as (W/m^2)
NOTE: the non-uniform heat flux should stay static all the run_time (doesn't change with time)
I hope can anyone could help me

ghorrocks · July 3, 2011, 06:57

You might be able to use a 3D interpolation function. Just define the Z coordinate to be a dummy value.

iBra · July 3, 2011, 16:33

I am going to try it. Thank you

July 2, 2011, 07:59	how to use non-uniform source	#1
iBra New Member ibrahim Join Date: Jun 2011 Posts: 4 Rep Power: 14	hi guys i have a project contain a non-uniform source PROBLEM DESCRIPTION there is a receiver which absorbs heat flux (W/m^2). the heat flux in the surface of the receiver is non-uniform. I have the heat flux data as X,Y,Heat_Flux. is it possible to insert this data to ansys cfx? i try [Hot_Point] but the problem with this function. i cant enter the value as (W/m^2) NOTE: the non-uniform heat flux should stay static all the run_time (doesn't change with time) I hope can anyone could help me

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] swak4foam building problem	GGerber	OpenFOAM Community Contributions	54	April 24, 2015 16:02
Need help with boundary conditions: open to atmosphere	Wolle	OpenFOAM	2	April 11, 2011 07:32
DxFoam reader update	hjasak	OpenFOAM Post-Processing	69	April 24, 2008 01:24
RasInterFoam STRANGE RESULTS AT BOUNDARY	kumar2	OpenFOAM Running, Solving & CFD	8	March 24, 2008 18:38
DecomposePar links against liblamso0 with OpenMPI	jens_klostermann	OpenFOAM Bugs	11	June 28, 2007 17:51

July 3, 2011, 06:57		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,694 Rep Power: 143	You might be able to use a 3D interpolation function. Just define the Z coordinate to be a dummy value.

July 3, 2011, 16:33		#3
iBra New Member ibrahim Join Date: Jun 2011 Posts: 4 Rep Power: 14	I am going to try it. Thank you