Heat Transfer Between two Plates

neilth · July 10, 2011, 00:35

I have two circular plates in contact with one another, rotating at the same speed, inside an air enclosure. I have set a solid to solid interface on the inside surface of each plate. I have also added a heat flux on one plate which changes the temperature of the same plate but not the other. I have left the frame change to None, the pitch change at None and Mesh Connection at GGI. Is there something I have missed in this interface?

ghorrocks · July 10, 2011, 06:34

If it works properly, you have not missed anything. If it does not work you probably have.

July 10, 2011, 00:35	Heat Transfer Between two Plates	#1
neilth New Member Neil Heilemann Join Date: Apr 2011 Posts: 6 Rep Power: 14	I have two circular plates in contact with one another, rotating at the same speed, inside an air enclosure. I have set a solid to solid interface on the inside surface of each plate. I have also added a heat flux on one plate which changes the temperature of the same plate but not the other. I have left the frame change to None, the pitch change at None and Mesh Connection at GGI. Is there something I have missed in this interface?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Heat transfer coefficient - what is waht	Stan	FLUENT	28	December 29, 2021 16:29
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 03:32
Convective / Conductive Heat Transfer in Hypersonic flows	enigma	Main CFD Forum	2	November 1, 2009 22:53
How can I increase Heat Transfer at Domain Interf?	B.Simon	CFX	3	October 28, 2008 18:53
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 15:55

July 10, 2011, 06:34		#2
ghorrocks Super Moderator Glenn Horrocks Join Date: Mar 2009 Location: Sydney, Australia Posts: 17,691 Rep Power: 143	If it works properly, you have not missed anything. If it does not work you probably have.