 |
 |
 |
|
|
|
[Sponsors] | ||||
July 12, 2011, 10:23
|
how to mesh a group of thin plate
|
#1 |
|
New Member
Zhang wenlai
Join Date: Jul 2011
Posts: 1
Rep Power: 0  |
I want to simulate the wind passing through the air-conditioner. There are two tubes passing through many thin plates,and cooling the thin plates and wind.The thin plates aslo cooling the wind. It is very hard to mesh them. when i try to mesh them by automatic method, there are some negative volumes. so how can I mesh a model like this. Attachment is the picture of the model.
I would like someone can help me, thank you very much. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Mesh thin layer of solid cell for conduction | chingyinh | ANSYS Meshing & Geometry | 6 | December 21, 2012 00:52 |
| [ICEM] Unstructure Meshing Around Imported Plot3D Structured Mesh ICEM | kawamatt2 | ANSYS Meshing & Geometry | 17 | December 20, 2011 11:45 |
| problem with hex mesh for impingement plate | rskrishna87 | ANSYS Meshing & Geometry | 0 | May 10, 2011 07:33 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |
| Please help: Library case W771: No convergence | Alex Costa | Phoenics | 5 | August 3, 2004 18:54 |
Linear Mode
