 |
 |
 |
|
|
|
[Sponsors] | ||||
February 27, 2018, 13:55
|
Applying boundary conditions, porous media
|
#1 |
|
New Member
Swapnil Rane
Join Date: Sep 2017
Posts: 23
Rep Power: 8  |
I'm modelling a cork with the following BC's.
two outlet's pressure-- 1 atm pressure inside the cork-- 1.4 atm How do I set up the pressure's in CFX? Which pressure BC should I select in domain setting tab? |
|
|
|
|
|
February 27, 2018, 14:49
|
|
#2 |
|
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
Please show an image of what you are modelling and the boundary conditions you propose to use.
__________________
Note: I do not answer CFD questions by PM. CFD questions should be posted on the forum. |
|
|
|
|
|
|
February 28, 2018, 18:44
|
More data
|
#3 |
|
New Member
Swapnil Rane
Join Date: Sep 2017
Posts: 23
Rep Power: 8 |
the boundary conditions are as follows---
Two outlet's are at atmosphere, which pressure's to select? static or total? Cork is compressed-- 1.481 [atm] pressure. oxygen flows through it. porosity-- 0.2 permeability-- 2E-10 [m^2] How do I setup the pressure's for this problem? Also, should I add oxygen source point inside the cork? |
|
|
|
|
|
 |
| Tags |
| porous. cfx, pressure based solver |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem on boundary conditions (multi-phase, porous media, 3 flow domains) | Juun | FLUENT | 1 | November 19, 2023 01:06 |
| Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
| Question about adaptive timestepping | Guille1811 | CFX | 25 | November 12, 2017 17:38 |
| Implementation of boundary conditions for FVM | Tom | Main CFD Forum | 7 | August 26, 2014 05:58 |
| Boundary conditions? | Tom | Main CFD Forum | 0 | November 5, 2002 01:54 |
Linear Mode
