|July 25, 2011, 11:05||
fully developed profile expression
Join Date: Apr 2011
Posts: 13Rep Power: 6
I want to set a fully developed velocity profile at the inlet of a rectangular duct, so I am creating a new expression to set the equation of Shah & London.
In a part of the equation I have to raise (z/a)^m, where m=2.37. I get an error when I try to set a non-integer value for m. If, for example, I use m=3, everything works fine. Any suggestions about the problem?
|Thread||Thread Starter||Forum||Replies||Last Post|
|translational periodic BC vs Fully Developed Profile at Inlet||Prakash.Paudel||FLUENT||1||August 20, 2010 11:01|
|Fully developed flow ,CEL expression||kmgraju||CFX||0||August 6, 2010 04:15|
|Fully developed flow profile||icfd||Main CFD Forum||3||May 20, 2009 22:21|
|Writing an expression for fully developed flow!||Usman||CFX||12||December 20, 2007 12:26|
|inlet velocity profile for fully developed turbule||pankaj saha||Main CFD Forum||4||August 24, 2007 16:53|