|
[Sponsors] |
August 7, 2011, 10:19 |
Post Process in CFX
|
#1 |
Member
Hamed
Join Date: Oct 2009
Posts: 64
Rep Power: 16 |
Dear friends
In CFX post processing I want to show a chart but as shown in attached file the number of points including chart is very low and so the quality of curve is awful however the grid quality is very good, does any body know how can I increase the number of containing point in the chart ? regards |
|
August 7, 2011, 18:56 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,697
Rep Power: 143 |
Increase the number of sampling points or use the cut option. Then it will generate a point at every control volume intersection and therefore give the full resolution of your mesh.
|
|
August 9, 2011, 03:07 |
Thank you
|
#3 |
Member
Hamed
Join Date: Oct 2009
Posts: 64
Rep Power: 16 |
Thank you very much
Sincerely |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CFX Post export problem | jeff_F | CFX | 0 | August 17, 2009 21:25 |
chart for transiente simulation - CFX Post | rogbrito | CFX | 0 | June 22, 2009 12:12 |
CFX 11, post | Anant | CFX | 1 | June 24, 2008 11:03 |
ANSYS CFX POST State file | Mechstud | CFX | 1 | June 22, 2007 14:59 |
Proper output of angle of attack in CFX post | Kevin | CFX | 3 | October 18, 2006 12:18 |