|
[Sponsors] |
September 21, 2011, 05:54 |
FSI - wind-induced vibration of plate
|
#1 |
Member
^^
Join Date: Aug 2011
Posts: 70
Rep Power: 14 |
Hi All,
I simulate wind-induced vibration of plate using FSI (transient structura - CFX) In Structural, I defined remote displacement of side of plate. (see Fig2). the condition of remote displacement is x: 0, Y: free, z: 0, rot-x: 0, rot-y: 0, and rot-z:Free. Because I would like to see vibrate at Y-dir and rotate z-dir. (it is same condition of wind tunnel test). but, I have an error of CFX via FSI. 1. Mesh folded error. I alread poted thread about this error but still problem. ANY IDEAS are welcome Last edited by colopolo; September 22, 2011 at 19:59. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
FSI - Wind Turbine | AUN | CFX | 13 | August 29, 2012 16:44 |
Free vibration of plate | colopolo | FLUENT | 0 | September 8, 2011 02:51 |
vibration of a rotating plate in water | zhm | Main CFD Forum | 0 | March 2, 2010 18:50 |
Simulation of Flow induced vibration on an elastically mounted bluff body in a cross | pradeepta | FLUENT | 2 | September 17, 2009 07:18 |
FSI oscillating plate | spatialtime | CFX | 4 | April 29, 2009 15:04 |