|September 21, 2011, 08:45||
Difference between Volume Fraction and Mass Fraction in CEL
Join Date: Aug 2011
Posts: 10Rep Power: 6
I'm doing with a multiphase multicomponent flow, dealing with volume fractions and mass fractions all the time.
Right now I'm writing some expressions within CEL and I have some doubts.
Let's say I have two phases (Phase 1 and Phase 2) each one with 2 components (Comp A and Comp B in Phase 1 and Comp C and Comp D in Phase 2).
1 - When I wirte "Phase 1.Volume Fraction" I get the Phase 1 volume fraction and when I write "Phase 1.Mass Fraction" I get Phase 1 mass fraction. Right?
2 - When I write "Phase 1.Comp A.Volume Fraction" I get Comp A volume fraction within Phase 1 and when I write "Phase 1.Comp A.Mass Fraction" I get Comp A mass fraction within Phase 1. Right?
3 - What should I write to get Comp A volume and mass fraction relative to the whole system, i.e. considering the volume and mass ocupied also by Phase 2???
Thanks a lot
|cel, component, fraction, phase, volume|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Error message: Insufficient Catalogue Size||Paresh Jain||CFX||29||January 10, 2016 02:18|
|Water subcooled boiling||Attesz||CFX||7||January 5, 2013 04:32|
|mass flow in is not equal to mass flow out||saii||CFX||2||September 18, 2009 08:07|
|air bubble is disappear increasing time using vof||xujjun||CFX||9||June 9, 2009 07:59|
|volume fraction, Mass fraction and Bulk Mass flow||Dr.jones||CFX||1||January 25, 2006 05:32|