|
[Sponsors] |
October 12, 2011, 14:25 |
Error in Solver
|
#1 |
New Member
Join Date: May 2011
Posts: 15
Rep Power: 14 |
Hi, I am modeling a ball that is in a channel with a transient velocity being applied to the water in the channel. However, I have experienced the error below when I solve it, anyone can assist? Appreciate it.
Details of error:- ---------------- Error detected by routine PEEKCS CDANAM = /FLOW/BOUNDCON /BCP3 /ALIAS CRESLT = NONE Current Directory : /FLOW/CONTROL/OUTPUT/MONITOR/MONP1/EXPVAL +--------------------------------------------------------------------+ | ERROR #001100279 has occurred in subroutine ErrAction. | | Message: | | Stopped in routine MEMERR | | | | | | | | | | | +--------------------------------------------------------------------+ +--------------------------------------------------------------------+ | An error has occurred in cfx5solve: | | | | The ANSYS CFX solver exited with return code 1. No results file | | has been created. | +--------------------------------------------------------------------+ End of solution stage. |
|
October 12, 2011, 19:16 |
|
#2 |
Super Moderator
Glenn Horrocks
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 17,703
Rep Power: 143 |
Looks like there could be a problem with your monitor points. Try removing your monitor points and see if that fixes the problem.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
A New Solver for Supersonic Combustion | nakul | OpenFOAM Announcements from Other Sources | 19 | February 27, 2024 09:44 |
[Other] A New Solver for Supersonic Combustion | nakul | OpenFOAM Community Contributions | 20 | February 22, 2019 09:08 |
thobois class engineTopoChangerMesh error | Peter_600 | OpenFOAM | 4 | August 2, 2014 09:52 |
Development of a Low mach PISO solver | nishant_hull | OpenFOAM Programming & Development | 0 | August 25, 2009 12:48 |
why the solver reject it? Anyone with experience? | bearcat | CFX | 6 | April 28, 2008 14:08 |