Rotating and moving frame of reference in Turbomachinary

Absid · September 10, 2019, 04:55

I was able to solve a problem involving compressor - using turbo mode ( rotating frame of reference). Is it possible for me to do the same analysis in stationary frame of reference by adding centrifugal and coriolis force so that i could validate my results? Please help

sasanghomi · September 24, 2019, 04:30

Rotating reference of frame method adds the centrifugal and coriolis terms to the equations (NS). So, I think for the validation process you can go through transient solutions (Moving boundaries and Dynamic Mesh) which has a high computational cost.

September 10, 2019, 04:55	Rotating and moving frame of reference in Turbomachinary	#1
Absid New Member Sai Abhishek Siddhartha Join Date: Sep 2019 Posts: 5 Rep Power: 6	I was able to solve a problem involving compressor - using turbo mode ( rotating frame of reference). Is it possible for me to do the same analysis in stationary frame of reference by adding centrifugal and coriolis force so that i could validate my results? Please help

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Rotating mesh in a moving reference frame	mafz1g11	FLUENT	1	March 23, 2019 00:13
Moving reference frame for turbine simulation	Rahl141	STAR-CCM+	2	December 28, 2017 06:25
Inertial and non-Inertial Reference Frame for Rotating Flows	emreozmen	Main CFD Forum	0	January 30, 2017 04:08
Rotating Cylinder (Moving wall vs Moving reference frame vs Sliding mesh)	hamed.majeed	FLUENT	2	January 17, 2017 12:18
Rotating wall B.C. versus Moving Reference Frame	cecilia_xiao559	Main CFD Forum	4	November 6, 2015 10:25

September 24, 2019, 04:30		#2
sasanghomi Senior Member Sasan Ghomi Join Date: Sep 2012 Location: Denmark Posts: 292 Rep Power: 14	Rotating reference of frame method adds the centrifugal and coriolis terms to the equations (NS). So, I think for the validation process you can go through transient solutions (Moving boundaries and Dynamic Mesh) which has a high computational cost.