|November 3, 2011, 00:56||
Entopy generation in CFX
Join Date: Sep 2011
Posts: 4Rep Power: 5
I need to find the entropy generation in a channel with heaters in the CFX. Because the program does not calculate the entropy generation, I've decided to make a new approach: I've collected the speed and temperature gradient data generated by CFX, calculated the entropy generation at each point and then I took the entropy generation mean value. This approximation is valid? What are the other ways to find the entropy generation? How can I introduce the entropy generation PDEs in CFX? I know that I can do this by creating a FORTRAN routine, but I haven't found where do I write this routine in CFX.
I know this subject has already been discussed in this forum, but I looked for this and haven't found any answer about it.
Thanks again in advance
|Thread||Thread Starter||Forum||Replies||Last Post|
|Different flow pattern between OpenFOAM and CFX||AirS||OpenFOAM||0||January 12, 2010 08:08|
|heat generation in CFX||Ema||CFX||4||August 7, 2009 06:39|
|Electronics Enclosure Analysis with CFX||Simulation Engineer||CFX||1||April 22, 2009 12:08|
|CFX 10 in CFX 5.7||panneerselvam.R||CFX||6||February 6, 2006 04:56|
|CFX 4.4 installation problem||Pandu Sattvika||CFX||1||December 1, 2001 05:07|