Help needed for my project
I am doing flow analysis inside the artery . considering the artery has porous property
I setup all the condition . When I give run , I got error.
I have attached the output file . Please help me where I did mistake
The error message says it all. You have turned extend min/max off on your profile function, but then asked for a value outside the defined profile in your initial condition. So it bombs out with an error. Read the error message carefully.
help needed for my project
I also tried two ways.
1.Turned off extend min/max
2. Turned on extended min/max
I am trying for the past two days for the transient analysis. I did not get the proper solution
Please find my profile(t)
and output file
please help me to solve the problem
Use a smaller time step.
|All times are GMT -4. The time now is 13:41.|