|March 13, 2012, 08:00||
Wall at outlet
Join Date: Nov 2010
Posts: 9Rep Power: 0
I am getting wall at outlet.Even though I have extended outlet also simulation is with using porous media.
Stream wise coeff multiplier is 10.
Geometry is simple long pipe with elbow at inlet and rectangular cross section at outlet.
Porous media is inserted in rectangular cross section.
|March 13, 2012, 17:35||
Join Date: Mar 2009
Location: Sydney, Australia
Posts: 12,831Rep Power: 100
The warning message simply says you are getting back flow at the outlet so it has generated artificial walls to stop it. If this is not affecting the accuracy of your simulation then ignore it. If it is then you have to move your exit boundary further away.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Inlet and outlet boudary without wall between||Janshi||CFX||5||February 2, 2012 05:51|
|A wall has been placed at portion(s) of an OUTLET||aero123||CFX||1||November 9, 2011 19:14|
|solution problem : A wall has been placed at portion(s) of an OUTLET||alnabhani||CFX||1||August 8, 2010 18:46|
|Combining BCs: wall - outlet. Boundary layer disappears||MartinaF||OpenFOAM Running, Solving & CFD||1||July 20, 2009 18:14|
|Multicomponent fluid||Andrea||CFX||2||October 11, 2004 05:12|