[fluid vertical turbine]

I try to use the icem CFD Replay Remeshing to simulate this case： the vertical is vabrate when it is rotating. the model is as following:
model.gif[/IMG]
it composed by four part:the vertical part,the vebrating part,the up and down static part.
then now I do it as tutorials step by step,I creat the files: .tip and .rpl
but when a cfx-solver run to remshing,the icem start automatic and it get the fault.it said as: wrong.gif[/IMG]
can give any advice about what's the cause of this probleam,and how to fix it (I use ansys 13.0,is it the problem of istalltion). thank you very much.
--------------------------------------
the other probleam is how to prview the motion of mesh(to check the motion of mesh is right or not) .
--------
thank you !