How to set boundary condition for damper tuturial?

klausb · March 30, 2013, 14:16

Hello,

I installed enGrid 1.4 and am working on the damper tutorial. Unfortunately I don't get too far.

When I try to set a boundary condition by "...point the mouse over a triangle of the symmetry plane and press the P key on your keyboard.", a dialog window opens offering to select point or cell.

How can I pick the symmetry plane in version 1.4?

Klaus

ogloth · April 2, 2013, 15:26

Hi Klaus,

try a lower case "p" instead of an upper case "P" ... admittedly stupid trap!

Cheers,
Oliver

March 30, 2013, 14:16	How to set boundary condition for damper tuturial?	#1
klausb Member Klaus Join Date: Mar 2009 Posts: 51 Rep Power: 6	Hello, I installed enGrid 1.4 and am working on the damper tutorial. Unfortunately I don't get too far. When I try to set a boundary condition by "...point the mouse over a triangle of the symmetry plane and press the P key on your keyboard.", a dialog window opens offering to select point or cell. How can I pick the symmetry plane in version 1.4? Klaus

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Boundary condition set up	p3vd	FLUENT	2	January 24, 2012 13:29
How to set boundary condition in supersonic airflow	sailor	FLUENT	0	December 14, 2011 01:44
External Radiation Boundary Condition for Grid Interface	CFD XUE	FLUENT	0	July 9, 2010 02:53
External Radiation Boundary Condition (Two sided wall), Grid Interface	CFD XUE	FLUENT	0	July 8, 2010 06:49
Convective Heat Transfer - Heat Exchanger	Mark	CFX	6	November 15, 2004 15:55

April 2, 2013, 15:26		#2
ogloth Super Moderator Oliver Gloth Join Date: Mar 2009 Location: Todtnau, Germany Posts: 94 Rep Power: 6	Hi Klaus, try a lower case "p" instead of an upper case "P" ... admittedly stupid trap! Cheers, Oliver