CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   enGrid (http://www.cfd-online.com/Forums/engrid/)
-   -   Volume meshing problem (http://www.cfd-online.com/Forums/engrid/122102-volume-meshing-problem.html)

Tensian August 12, 2013 08:45

Volume meshing problem
 
2 Attachment(s)
Hi everyone,

I am having some problems with BL meshing in ENGRID.

First of all I improved my surface mesh (I am using the 1.3 version, so it can let me define suitable edge lenghts for each boundary), with no edges longer than 0.0008 m. Then I mesh the volume and create boundary layer (see attached file for data). Sometimes I see like triangles of the surface mesh appear inside the BL. But in this case, I have not seen that. So when BL is created (it takes some hours) and I try to mesh volume again or divide prismatic BL ENGRID shows an error message like the one in the image attached.Attachment 24321

Have anyone idea of whatīs happening? I canīt see any triangle overlapping prismatic layer! And when I didnīt touch the surface mesh values there was not any problem...

Thanks in advance for the suggestions!

Curro5150 January 23, 2014 18:06

Check that you don't have overlapping faces in your geometry. I was having the same problem and it was related to overlapping faces in the .stl
That solved the problem, although I am getting now a different error :-(


All times are GMT -4. The time now is 01:24.