 |
 |
 |
|
|
|
[Sponsors] | ||||
November 22, 2013, 07:45
|
Problem going from surface to volume mesh
|
#1 |
|
New Member
Join Date: Oct 2013
Posts: 2
Rep Power: 0  |
Hello everyone,
I am currently having great difficulty doing the volume mesh of a simple naca0012 wing, check surface integrity is fine and no overlapping surfaces are found. I believe this is an unprecedented bug, whatever the way I do the surface mesh, Engrid stops at "blockfill local h", it doesn't crash but the next step seems impossible to start. I enclosed my case and geometry, thanks in advance! Mark |
|
|
|
|
|
November 26, 2013, 02:03
|
|
#2 |
|
Senior Member
Oliver Gloth
Join Date: Mar 2009
Location: Todtnau, Germany
Posts: 121
Rep Power: 17 |
Hello Mark,
I have downloaded your case and will have a look at it and keep you updated. Best regards, Oliver |
|
|
|
|
|
|
January 9, 2014, 08:05
|
|
#3 |
|
New Member
Join Date: Oct 2013
Posts: 2
Rep Power: 0 |
Hello Oliver,
Any luck with my mesh? Regards, Mark |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problem of simulating of small droplet with radius of 2mm | liguifan | OpenFOAM Running, Solving & CFD | 5 | June 3, 2014 02:53 |
| [ICEM] How to generate sunstructured "all-tri patch-dependant" surface mesh in ICEM? | jash | ANSYS Meshing & Geometry | 19 | July 23, 2013 18:48 |
| [blockMesh] Problem with Mesh Volume | seboxx | OpenFOAM Meshing & Mesh Conversion | 3 | January 30, 2012 08:19 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
Linear Mode
