|August 5, 2013, 08:35||
Solver abnormally terminated.Please contact the support service
Join Date: Sep 2012
Posts: 3Rep Power: 4
I was wondering if someone could advise me regarding an issue with solidworks flow simulation. I am running a transient simulation which take days to finish for each simulation. Previously I can stop the simulation at any time during the simulation and save the current data. Then the simulation can be continue later.
However, I found that recently for different model, whenever i stop the simulation and try to continue it later, this message will appear
' Solver abnormally terminated. Please contact the support service'. I have check that I have no issue with RAM and hard disk space. Also the model is correct.
Therefore, I am really appreciate if someone can advise me regarding this issue.
|September 4, 2013, 07:12||
Join Date: Jul 2009
Posts: 378Rep Power: 12
It is hard to tell why this is happening if it is depending on the model but works for all the others. It would be best to contact your support and send them the model if this problem is only related to that model and explain when it happens.
In general it is not recommended to stop and continue calculations, especially not too often and with transient simulations.
I don't know your model setup but if the simulation takes that long you might have not set the manual time step or you might also be able to apply flow freezing in some cases but that depends on the type of simulation.
Sometimes the manual time step does not help a lot if the model is very complex or large and you consider a long physical time. As I said I don't know your model and project settings.
|Thread||Thread Starter||Forum||Replies||Last Post|
|OpenCL linear solver for OpenFoam 1.7 (alpha) will come out very soon||qinmaple||OpenFOAM Announcements from Other Sources||4||August 10, 2012 11:00|
|CFX11 + Fortran compiler ?||Mohan||CFX||20||March 30, 2011 18:56|
|Ansys Workbench contact problem!||JoelHenrik||ANSYS||1||October 1, 2010 14:57|
|Does the Star-CCM+ solver support structured grids?||peresah||STAR-CCM+||8||January 12, 2010 03:57|
|Setting a B.C using UserFortran in 4.3||tokai||CFX||10||July 17, 2001 16:25|