CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FloEFD, FloWorks & FloTHERM (http://www.cfd-online.com/Forums/floefd-floworks-flotherm/)
-   -   Pressure distribution into Mechanica (http://www.cfd-online.com/Forums/floefd-floworks-flotherm/123314-pressure-distribution-into-mechanica.html)

-mAx- September 10, 2013 01:40

Pressure distribution into Mechanica
 
Hello,
Do we need a special installation of ProMechanica, for importing a pressure distribution on a surface from FloEFD (for Creo) into ProMechanica?
Thank you for any information

Boris_M September 16, 2013 02:41

Hi Maxime,
no, you shouldn't.
Do you have any troubles applying the pressure distribution?

Boris

-mAx- September 17, 2013 01:26

1 Attachment(s)
Hello Boris,
Now it is ok, I found the option in pressure load's panel
Now I have to play a little bit with this tool, because ProM is asking me the value of the pressure, (but it is supposed to be calculated with FloEFD).
I will run a job with a pressure of 1 Pa to see what FloEFD is exporting exactly ...
From the pressure load panel, I understand I loaded an extern field coefficient and not a true pressure load
anyway, I will digg it
Attachment 25416

Boris_M September 17, 2013 06:31

Hi Maxime,

I have a how-to guide for you if you send me your email adress in a private message. Or you can also find it on our SupportNet website.

Regards,
Boris

PS: Gre aus Frankfurt :-) I saw your german GUI


All times are GMT -4. The time now is 07:02.