 |
 |
 |
|
|
|
[Sponsors] | ||||
September 24, 2013, 04:30
|
Component Control
|
#1 |
|
Member
Christian
Join Date: Sep 2013
Location: Germany
Posts: 88
Rep Power: 12  |
Hello everybody,
i got a little issue with the component control. I cant switch off some parts in my model. Can you help me? Im new to Floefd... |
|
|
|
|
|
September 30, 2013, 10:45
|
|
#2 |
|
Disabled
Join Date: Jul 2009
Posts: 616
Rep Power: 23 |
Hi Chris,
Can you tell me more about what exactly is not working. Do want to switch off some parts but they are not listed in the component controls or if you switch them off they are still there? Or what is your problem exactly? Boris |
|
|
|
|
|
|
October 11, 2013, 04:43
|
|
#3 |
|
Member
Christian
Join Date: Sep 2013
Location: Germany
Posts: 88
Rep Power: 12 |
I switched them off but they where still in the simulation. It worked when I switched all components off and on again. Dont know why. Thanks for your reply :-)
|
|
|
|
|
|
|
October 11, 2013, 04:48
|
|
#4 |
|
Disabled
Join Date: Jul 2009
Posts: 616
Rep Power: 23 |
Maybe it was just not updated for the simulation. Or you didn't re-mesh it after it was in the simulation the first time before you switched it off. That can happen too.
At least it seems to work now, does it? Boris |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Error message: Insufficient Catalogue Size | Paresh Jain | CFX | 32 | February 3, 2021 03:37 |
| Low Mixing time Problem | Mavier | CFX | 5 | April 29, 2013 00:00 |
| FSI: Pressure and Normal Force don't match with expected values | Geraud | CFX | 6 | August 21, 2012 15:34 |
| Match Control and Symmetry Boundary Condtions in a quasi 2D calculation | peterputer | ANSYS Meshing & Geometry | 0 | May 15, 2012 08:53 |
| combustion problem | mcnair | CFX | 9 | March 22, 2011 14:06 |
Linear Mode
