|
[Sponsors] |
April 24, 2016, 17:12 |
Rotation in flow simulation
|
#1 |
New Member
Selim
Join Date: Apr 2016
Posts: 1
Rep Power: 0 |
I'm facing an issue with my pump flow simulation as every time i click on run ( Solver abnormally terminated) message appear.
|
|
April 29, 2016, 04:37 |
|
#2 |
New Member
A. Lindgren
Join Date: Feb 2016
Posts: 6
Rep Power: 10 |
Are you using a rotating region? If so make sure the region boundary is rotationally symmetric.
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Flow rate restriction simulation set-up | siw | CFX | 4 | February 16, 2016 12:15 |
Preparing Simulation of a Sphere in a Flow | PonchO | OpenFOAM Pre-Processing | 1 | November 11, 2015 15:40 |
Flow Simulation : air around an rotating cylinder using Solidworks Flow Simulation | Wyrold | Main CFD Forum | 0 | October 22, 2015 08:48 |
parametric study in flow simulation | topaz | FloEFD, FloWorks & FloTHERM | 1 | July 13, 2015 08:50 |
Expert parameter to stop the fluid flow simulation | KK | CFX | 1 | February 25, 2008 16:29 |