 |
 |
 |
|
|
|
[Sponsors] | ||||
May 30, 2012, 06:20
|
Particules in fluid
|
#1 |
|
New Member
Join Date: May 2012
Posts: 1
Rep Power: 0  |
Hello,
I would like to know how simulate particules in fluid. I explain myself. I would like to simulate a cartridge for fuel. This cartridge needs to stop the particules (pollutant particules) of the fuel. How can i do that? I try to put 2 differents fluid/gaz but it is not too realistic. Thank you for your help 
|
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] ICEM Scripting Issues | tylerplowright | ANSYS Meshing & Geometry | 17 | June 3, 2012 21:23 |
| mass flow in is not equal to mass flow out | saii | CFX | 2 | September 18, 2009 08:07 |
| My Revised "Time Vs Energy" Article For Review | Abhi | Main CFD Forum | 2 | July 9, 2002 09:08 |
| Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
| fluid hot volume in fluid cold volume | zahid | FLUENT | 4 | June 1, 2002 09:11 |
Linear Mode
