|September 24, 2012, 09:27||
about modelling of baffles in Flow-3D
Join Date: Sep 2012
Posts: 1Rep Power: 0
I am self-learning Flow-3D to try to simulate the rank sloshing with baffles insides. now i can do the case of without baffle. but while baffles added in, i mean that baffles are plates with somh big holes in center area. Shall I input those baffles with STL and placed them into correct design position then do the boundary setting? Or I can use the baffles definition inside ( i once tried. no respone...).
Could you please post here some of your ideas on modelling baffles if it came from STL geometry and how to define the boundary condition of it?
so many appreciates...
|Thread||Thread Starter||Forum||Replies||Last Post|
|Modelling Supersonic TwoPhase Flow with Phase Change||wes||OpenFOAM Running, Solving & CFD||7||September 10, 2015 07:54|
|CFD modelling of two phase flow in cyclone separator||rajeshkunwar||Main CFD Forum||0||April 21, 2009 09:35|
|modelling blood flow in arteries with starcd||sara||CD-adapco||5||April 10, 2007 09:17|
|Modelling flow around a ship's hull using vof||Manoj Kumar||FLUENT||0||February 26, 2005 17:22|
|Basic Multiphase Flow Modelling||krishna||Main CFD Forum||2||August 27, 2004 08:40|