[pyxbird]

Hi,all dears,
I have some questions:
1. I am simulating the flow structure around a vertical cylinder under steady current condition, the velocity of the current is about 3m/s, the height of the vertical cylinder is 14m, the depth of the water is 25m, the diameter fo the cylinder is 3m. The grid I use is fine enough, and I simulate the problem for 60 seconds. However from the streamlines I can see that it looks like a laminar flow more and the turbulence is not intensive. What might be wrong with my simulation?
2. I encounter with some messages given by the solver, but I don't understand where do the errors come from? I will show it below:

============= mentor tip ===============
there is no reference pressure available.
========================================
while writing record no. 6710887
...trying to re-write record

word addressable i/o error no. 38
while writing record no. 6710887
...trying to re-write record

word addressable i/o error no. 38
while writing record no. 6710887
...trying to re-write record

word addressable i/o error no. 38
while writing record no. 6710887

k8= 160 k= 160
waout flsgrf



error 52 detected
errtrp_h

[JBurnham]

Usually this error is because the hard drive is full. Check that you have space. Otherwise, it may be related to your specific version, and I would suggest contacting FLOW-3D support directly.