CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLOW-3D (http://www.cfd-online.com/Forums/flow-3d/)
-   -   k and epsilon were hard to converge in multiphase model (http://www.cfd-online.com/Forums/flow-3d/111265-k-epsilon-were-hard-converge-multiphase-model.html)

Yanlong Li January 2, 2013 05:09

k and epsilon were hard to converge in multiphase model
 
Hi,

:oMy modeling is Injecting gas into Laddle from the bottom. use VOF and k-epsilon models, the time step size is 0.0001s, Residuals were set as 10-5. At the beginning, about 0~0.1s, It was easy to converge. but after that, the k and epsilon became harder and harder to vonverge. I changed mesh, decreased Under-Flaxation-Factor, changed the MultiGrid. But I did not work. Do you have any idea to get through this confusion ?

Thanks in advance:p

Long


All times are GMT -4. The time now is 03:22.