Flow 3D Cast_can not run simulation

pcapsa · June 14, 2013, 09:36

Hello everyone
I am new to the Flow 3D Cast and ask for help.
I just finished example of HPDC FILLING TUTORIAL but can not run Velocity, or any other simulation.
For simplicity I made an example with only one Mesh Block.
I guess the problem is that the value of Time is zero, but I do not know how to increase it.
Can somebody help me.

melissa · June 19, 2013, 11:09

Hello,

There is an error in the exercise for the thermal conductivity and the density*specific heat for the anvilloy.

To fix it go to Solid objects select Core then select the custom button
reverse the parameters select ok
save
run again

let me know if this fixed the problem

pcapsa · June 21, 2013, 04:21

Yes , Thank you very much melissa

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Channel flow setup in Large-eddy simulation	Weihua	Main CFD Forum	6	November 17, 2015 09:33
Internal flow simulation BCs	SteveGoat	FLUENT	0	May 10, 2012 06:41
Differences and functions of Solidworks Simulation and Solidworks Flow Simulation?	alpharays	Main CFD Forum	0	April 19, 2012 03:13
Wing lift in Solidwork Flow Simulation	brianmcv	Main CFD Forum	6	April 11, 2011 08:16
fluid flow fundas	ram	Main CFD Forum	5	June 17, 2000 21:31

June 19, 2013, 11:09		#2
melissa Member MC Join Date: Mar 2009 Posts: 56 Rep Power: 17	Hello, There is an error in the exercise for the thermal conductivity and the density*specific heat for the anvilloy. To fix it go to Solid objects select Core then select the custom button reverse the parameters select ok save run again let me know if this fixed the problem

June 21, 2013, 04:21		#3
pcapsa New Member Join Date: Jun 2013 Posts: 3 Rep Power: 12	Yes , Thank you very much melissa