 |
 |
 |
|
|
|
[Sponsors] | ||||
November 13, 2013, 14:43
|
negative flow rate values
|
#1 |
|
Member
ouni firas
Join Date: Oct 2013
Posts: 33
Rep Power: 12  |
i'm simulating a rectangular channel with a weir which is placed in the middle of channel. I want to obtain the Value of the discharge Q ,so ,I have defined the BAFFLE as a flux surface at the end of the channel and I found negative flow rate values, and more when I open the file fluid volume I was surprised by the presence of the volume value for a very short time, before the flow reaches the BAFFLE, I did not find an explanation. thank you for the explanation
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Mass flow rate at the outlet | tejasvikrishna | FLUENT | 2 | May 25, 2013 02:42 |
| [blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
| calculating mass flow rate from exported velocity values | Sasha | FLUENT | 0 | April 6, 2009 16:07 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
| sos! How to define the flow rate of outflow BC? | zjm | FLUENT | 0 | June 4, 2004 09:12 |
Linear Mode
