CFD Online Discussion Forums

CFD Online Discussion Forums (http://www.cfd-online.com/Forums/)
-   FLOW-3D (http://www.cfd-online.com/Forums/flow-3d/)
-   -   how to show the units on the results. (http://www.cfd-online.com/Forums/flow-3d/126589-how-show-units-results.html)

ounifiras November 21, 2013 04:35

how to show the units on the results.
 
how to show the units on the schemas results. I has used> Analysis> 3D> Units> Plotting Units> SI. and I check> Show units on studs, but the results are shown without UNITs, I have not found an explanation?

JBurnham November 24, 2013 17:07

You need to set the unit system on the Model Setup > General tab before you run the simulation. Only then can does the output file contain info about what the original units are so that they can be converted or shown on output plots. Otherwise what you did is correct.


All times are GMT -4. The time now is 18:16.