|December 8, 2013, 09:34||
Flow-3D CAST Iron Solidification
Join Date: Nov 2013
Posts: 11Rep Power: 3
I simulated solidification of Ductile iron (GGG40) using FLOW-3D Cast. All information about the physical properties of austenite, carbide and graphite (like density) were entered into the software. I expected to see yield and UTS stress, ferrite and pearlite and graphite distribution at the end of solidification.
Unfortunately, amount of graphite and carbide percentage were negative and was not distributed in all the cast uniformly in post processor.
Besides, I couldn't find any results about prediction of mechanical properties and microstructure of cast (yield, UTS, ferrite, pearlite...).
I was wondering if you could help me to find my answers.
|Thread||Thread Starter||Forum||Replies||Last Post|
|swak4Foam installation problem||Claudio87||OpenFOAM||9||May 8, 2013 10:20|
|Flow meter Design||CD adapco Group Marketing||CD-adapco||3||June 21, 2011 08:33|
|latest OpenFOAM-1.6.x from git failed to compile||phsieh2005||OpenFOAM Bugs||25||February 9, 2010 05:37|
|mass flow in is not equal to mass flow out||saii||CFX||2||September 18, 2009 08:07|
|Gentoo Compilation woes on AMD64 with fluentMeshToFoamL||connclark||OpenFOAM Installation||8||February 29, 2008 15:18|