Early finish time
I am quite new in using flow-3D simulation software. I am runing a simulation that should simulate a 120 s long interaction between hot gases and water in sertain geometry. However the simulations ends after 6 - 8 seconds. Is there a reseon for that or did it crashed? Thank you for your reply (sorry for my english)
What is your stop criteria? Most of the time this problems is due to set incorrect stop criteria!
However I am Flow-3D CAST user and don't hesitate if you have any question!
this is my e-mail address: firstname.lastname@example.org if you want contact with me.
M. R. Sharifabadi
|All times are GMT -4. The time now is 21:32.|