cf packing

razieh anari · January 23, 2014, 09:40

is f-packing related to foam and void in flow?
if it is, how can we do? does flow 3d reduce or change it automatically? or we should change it?
my simulation is very very slow and warns reduce f-packing.
what is the effect of reduced f- packing on result of simulation?

dmilano · February 11, 2014, 17:17

The f-packing algorithm is used to collapse unresolved void regions in the flow. Treat the f-packing warnings as a caution and look to see if the results in that area still make sense. If the results look okay, then don't worry about the messages.

Usually you'll see the f-packing warnings when there is a lot of splashing, which is the more likely the cause of the slow simulation. You can try setting FCLEAN to reduce the splashing or use the implicit velocity threshold to minimize its effect on the run time.

January 23, 2014, 09:40	cf packing	#1
razieh anari New Member razieh anari Join Date: May 2013 Posts: 6 Rep Power: 12	is f-packing related to foam and void in flow? if it is, how can we do? does flow 3d reduce or change it automatically? or we should change it? my simulation is very very slow and warns reduce f-packing. what is the effect of reduced f- packing on result of simulation?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fluent Convergence for particles packing	natantyt	FLUENT	0	March 7, 2012 12:01
[Other] Monte Carlo Packing Problem	chegdan	OpenFOAM Meshing & Mesh Conversion	1	May 14, 2009 22:33
packing materials	shankar	FLUENT	2	October 4, 2006 23:54
Packing limit management in the Eulerian model	ap	FLUENT	2	September 16, 2005 17:46

February 11, 2014, 17:17		#2
dmilano Member Join Date: Mar 2012 Posts: 72 Rep Power: 14	The f-packing algorithm is used to collapse unresolved void regions in the flow. Treat the f-packing warnings as a caution and look to see if the results in that area still make sense. If the results look okay, then don't worry about the messages. Usually you'll see the f-packing warnings when there is a lot of splashing, which is the more likely the cause of the slow simulation. You can try setting FCLEAN to reduce the splashing or use the implicit velocity threshold to minimize its effect on the run time.